Maximum OUTPUT
due to intelligent application technology
Power by diversity
- Efficiency by variety – nozzle spacings of 25 and 50 cm are available
- With a 25 cm nozzle spacing the target area distance is reduced to an optimum
- Pneumatic individual nozzle control enables individual and intelligent application technologies
- Outstanding penetration and wetting of the crop
- Variable nozzle body combinations (pneumatically switchable):
1-0 one single nozzle body every 50 cm
1-0 (3M) one manual triple nozzle body every 50 cm
1-1 one single nozzle body every 25 cm
1-1 (3M) one manual triple nozzle body every 25 cm
2-0 one dual nozzle body every 50 cm
2-0 (4M) one manual quadruple nozzle body every 50 cm
2-1 one dual nozzle body every 50 cm, one single nozzle body as intermediate nozzle
2-2 one dual nozzle body every 25 cm
2-2 (4M) one manual quadruple nozzle body every 25 cm
4-0 one quadruple nozzle body every 50 cm
4-1 one quadruple nozzle body every 50 cm one single nozzle body as intermediate nozzle
4-2 one quadruple nozzle body every 50 cm one double nozzle body as intermediate nozzle
- As a standard, all nozzle body combinations are equipped with nozzle holders for edge / border nozzles.
AutoSelect System
- Various combination possibilities with up to 16 different nozzle profiles that can be saved
- Can be switched on or off from the cabin
- If the work is not interrupted, the optimum pressure range and the corresponding nozzle size are controlled automatically continuously.
- Automatic adaption of the boom height depending on the defined nozzle profiles based on the nozzle spacings that are defined in the nozzles profiles. Thus, with more nozzles the farmer has a wide range of options.
- Fully automatic AutoSelect control: Controls the nozzle size or nozzle combination while at the same time adapting the application rate
- High comfort and safety for an optimum management of the distance requirements along waters and terrestrial structures